Link: CentreWare IS Help
WorkCentre 6605 Help
Information Index
Host Access List Help

The host access list controls access to the printer over LPR or Port 9100. You can enter up to 20 IPv4 or IPv6 address/mask combinations. You can also select to accept, reject, or turn off the filtering for each IP address. You can enter a specific IP address and address mask, or you can enter a range of IP addresses and address masks. If you leave IP address and Address Mask blank, anyone can access the printe

You an choose to allow printing from one specific IP address only. The following table shows an example.

Access List IP Address Address Mask Operation
1 192.168.200.10 255.255.255.255 Accept

You can reject one specific IP address but allow printing from any other address. The following table shows an example.

Access List

IP Address

Address Mask

Operation

1 192.168.200.10 255.255.255.255 Reject
2 0.0.0.0 0.0.0.0 Accept

The first row of the access list is the highest priority. When configuring a list with multiple rows, enter the smallest range first. Make the first row the most specific and the last row the most general.
For example, you can set up the host access list to do the following:

  • Accept printing from a specific network.
  • Reject printing from a particular network mask within that network.
  • Accept printing from one particular IP address within that network mask.

The following table shows an example.

Access List IP Address Address Mask Operation
1 192.168.200.10 255.255.255.255 Accept
2 192.168.200.0 255.255.255.0 Reject
3 192.168.0.0 255.255.0.0 Accept

To configure the Host Access List:

  1. In the IP Address field, enter the IP address of the host as X.X. X.X, where X is a number from 0 through 255. For example, type 192.168.200.10.
  2. In the Address Mask field, enter the network mask for the host as X.X. X.X, where X is a number from 0 through 255. For example, type 255.255.255.255.
  3. For Operation, for the action the host takes with the IP address, select an option.
    • Off: You can use this setting to make a row of the access list inactive. Use this setting to enter a specific IP address or range of addresses before you apply Accept or Reject mode.
    • Accept: You can use this setting to allow the specified IP address or range of addresses access to the printer.
    • Reject: You can use this setting to deny the specified IP address or range of addresses access to the printer.
  4. Click Save Changes.
COPYRIGHT © 2014 Xerox Corporation. All Rights Reserved.
Link: Xerox website