When you set the IP addressing parameters from the front panel, the selections for DHCP/BOOTP and RARP are automatically set to Disabled.

1. Press Menu; the front panel displays Help Pages.
2. Press ----> or <---- until the front panel displays Network Settings.
3. Press Menu until the front panel displays TCP/IP.
4. To set the IP address:
1. Press Menu again; the front panel displays Interface.
2. Press ----> to display TCP/IP Address.
3. Press Select to display the IP address. For example:

192.2.194.101 + ----> Set NOTE Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address (see Setting IP parameters: RARP or BOOTP ).

4. Press + to set the left-most digit of the address.
5. Press ----> to advance to the next digit. Press + to set this digit.
6. Use ----> and + as described in Step  e to set the remaining digits.
7. When the address is correctly set, press Set to enter your settings into the printer; the front panel displays:

Confirm Selection Confirm NOTE When you press Confirm to set the IP address, the printer resets the network mask and broadcast address to the printer's defaults; see Printer defaults for network mask and broadcast address.

8. Press Confirm; the front panel briefly displays Selected, then returns to TCP/IP Address. The IP address is now set in the printer.
5. To set the network mask:
1. Press ----> until Network Mask is displayed.
2. Press Select; the front panel displays the network mask.
3. Use + and ----> as described in Steps 4d through 4f to set the network mask.
4. When the network mask is set, use Set and Confirm as described in Steps 4g and 4h to enter the network mask into the printer.
6. To set the gateway address:
1. Press ----> until Gateway Address is displayed.
2. Press Select; the front panel displays the gateway address.
3. Use + and ----> as described in Steps 4d through 4f to set the gateway address.
4. When the gateway address is set, use Set and Confirm as described in Steps 4g and 4h to enter the gateway address into the printer.
7. The printer calculates the broadcast address based on the IP address and the network mask. However, the broadcast address can be viewed and set using the following procedure:
1. Press ----> until Broadcast Address is displayed.
2. Press Select; the front panel displays the broadcast address.
3. Use + and ----> as described in Steps 4d through 4f to set the broadcast address.
4. When the broadcast address is set, use Set and Confirm as described in Steps 4g and 4h to enter the broadcast address into the printer.
8. Return the printer to normal operation.
1. Press Exit (the far left button) until the front panel displays Network Settings.
2. Press Exit again.
• If you have changed any parameters that require a printer reset to take effect, you will be prompted to reset the printer. If you press Reset, the printer resets. If you press Resume, the front panel displays Network Settings. Press Exit (the far left button); the printer returns to normal operation, but the changes you have made will not take effect until the next time the printer is reset.
• If you have not changed any parameters that require a printer reset to take effect, the front panel displays Ready.