Setting the printer's IP addressing parameters

Xerox.com

PhaserShare

Setting IP parameters: PhaserLink software

After setting the printer's IP address by one of the methods described in this guide, you can perform the rest of the TCP/IP configuration using PhaserLink software, if you have a World Wide Web browser. For more information on PhaserLink software, see PhaserLink Software: the Printer's Information Link.

From the printer's home page, click the Configuration button; this displays the View and Configure Settings page.
From the View and Configure Settings page, click View and Configure Interface Settings; this displays the View and Configure Interface Settings page.
From the View and Configure Interface Settings page, click View and Configure TCP/IP Settings; this displays the View and Configure TCP/IP Settings page.
Enter your printer's settings. If you make an error, you can click Restore Initial Form Values and start again.
When you are finished entering the settings, enter the Validation Password and click the Do/Apply button.
The printer responds by displaying a dialog box that allows you to reset the printer. The new parameters will not take effect until the printer is reset.

Return to Networking Topic List

Support Home Page

Network Printers Support Home

Additional Information

			Register your Printer
			ASPs & TPMs
			About Software Support
			Color Connection
			Printer Warranties
			Material Safety Data Sheets
			Supplies & Cartridge Recycling Program

Survey SoftwareEnterprise Feedback Management