SNMP Help

This page enables you to configure the settings for SNMP. Hosts must have Set and Get Community Names defined in their applications to access the printer using SNMP. If any changes are made to the Get, Set, and Trap Community Names for the printer, then each application that uses the SNMP protocol to communicate with the printer requires a corresponding Get, Set, and Trap Community Name.

Enable SNMP - Select this checkbox to enable SNMP.

Get Community Name - Enter the Community Name used for read-only access, up to 31 characters in length.

Set Community Name - Enter the Community Name used for read/write access, up to 31 characters in length.

Trap Community Name - Enter the Community Name used for trap notification, up to 31 characters in length.

Trap Notification (IP) 1-3

IP Address/IP Socket - Enter the IP address and IP socket in these fields. The IP address format is x.x.x.x, where x represents a decimal number from 0 - 255. The IP address value entered must not start with 127 or 224-254. The last field after the IP address contains the IP socket. The IP socket value must be a number between 0-65535.
Traps to be Received - Select the checkboxes to choose trap types to be sent to the specified address. You can select All Traps, Printer Traps, Job Monitoring Traps, Cold Start Traps, and Authentication Error Traps.

Authentication Error Trap - Select the Notify checkbox to notify authentication error traps.

When you are satisfied with your selections, click Save Changes to keep the settings or Discard Changes to keep the previous settings.