Static electricity precautions

• Leave the printer plugged into its power outlet; this preserves a ground path for static discharges.
• Touch the printer's bare metal frame often to discharge static electricity from your body.
• Handle the circuit board(s) by their edges only.
• Do not lay the board(s) on a metal surface.
• Make the least possible movements to avoid generating static electricity.
• Avoid wearing wool, nylon or polyester clothing; they generate static electricity.

On-site installation

Professional, on-site installation is just a phone call away. Productivity is important to your business success - so when you need it done right - the first time - call Tektronix. Tektronix' on-site installation delivers what you've been looking for: expert service technicians who provide quality, on-site product installation. In the United States and Canada, call 1-800-835-6100.

Phaser 560 installation

1. Power down the printer. Disconnect all host interface cables.
2. Remove the two screws securing the board's rear panel to the printer.
3. Grasp the rear panel by the knob and slide the board out of the printer card cage.
   NOTE: The printer only uses Tektronix proprietary RAM SIMMs.
   
   Installing a second RAM SIMM. If you are installing a second RAM SIMM in the printer, the larger capacity RAM SIMM must be installed in the SIMM 1 connector.
   
   16-Mbyte RAM SIMM (part number 671-3133-00) already installed. This SIMM may remain in the SIMM 1 connector if you are installing another 16-Mbyte RAM SIMM.
   
   32-Mbyte RAM SIMM (part number 671-3138-00) already installed. This SIMM must remain in the SIMM 1 connector.
4. If you are installing a single RAM SIMM. Insert a memory module in connector SIMM 1 (a) and tilt the module down until it locks in place (b). When properly inserted, a tab on each end of the connector slips into a hole on each end of the RAM SIMM. Also, a pawl on each end of the connector latches around each end of the RAM SIMM to lock it in place. Go to Step 6.
   
   If you are installing two RAM SIMMs. Review the second RAM SIMM limitations in the note above. Because of physical space limitations, install memory modules in the order SIMM 1 and then SIMM 2 with SIMM 1 holding the largest capacity RAM SIMM.
   
   Insert the appropriate memory module in connector SIMM 2 (a) and tilt the module down until it locks in place (b). When properly inserted, a tab on each end of the connector slips into a hole on each end of the RAM SIMM. Also, a pawl on each end of the connector latches around each end of the RAM SIMM to lock it in place.
5. Reinstall the image processor board into the printer.
6. Print a startup page to check its listing of the printer's memory and options. Update your host computer's printer driver; this involves configuring the printer driver residing on your computer. Refer to the printer user manual.