Phaser 3450
  > Support
  > Knowledge Base
  > FAQ
  > Drivers
  > Supplies


Support Topics
Step by step guides
  >  General Information
  >  Installation/Setup
  >  Printer Troubleshooting
  >  Troubleshooting Xerox Software
How To
  >  Replace Consumables (Print Cartridge, Fuser, etc.)
  >  Install a Driver
  >  Printer Setup
  >  Load Paper Trays
  >  Use the Front Panel

> Home > Support & Drivers > Phaser 3450 > Frequently Asked Questions

Phaser 3450 Support FAQ's
Q: What is a Guide?

A: Guides are step by step instructions that walk you to a solution based on questions that you answer
Installation and setup
I just got my printer, how do I set it up? (Out of box setup)
How do I download and install printer drivers?Guide
How do I install or replace the print cartridge?
How do I install or replace the printer's fuser?

Product Usage
What kind of paper/media can my printer use? Important!
How do I print on custom sized media?

Print Quality
My prints don't match what I see on my monitor. What do I do?Guide
I'm getting print quality problems from all my computers on everything I print. What do I do?
I'm getting print quality problems from my application/print job. What do I do?

Errors and Troubleshooting
Jams/Front Panel Messages
What do I do if I get a message on the front panel that says...
Jam at Tray...
Replace Print Cartridge
Jam at Duplex
This IP address is already in use...
Close Cover or Check Cartridge
Toner is Low
Fuser Failure
I'm getting some other message on my printer's front panelGuide

Other errors/issues
What do I do when...
The printer is turned on, but displays no power, lights, or sound? Or, the printer cycles on and off by itself?
I'm having trouble getting the printer on a network, or I'm having trouble printing to a networked printer?Guide (i.e. pings to the printer time out)
How do I load and print from Tray 1 (Multi-purpose tray MPT)
The computer or printer reports a PostScript Error: Invalid Access, Offending Command

^ BACK TO TOP