| Switch |
Function |
Settings |
| 1 |
Reset/run |
Up: The printer resets and does not accept data
while the switch is in this position. Down:
The printer runs a self-test, then proceeds to run normally. Leave the
switch down for normal operation. |
| 2, 3, 4 |
Configuration Page/
Diagnostics |
Up: When only Switch 4 is moved from down
to up, the printer prints a configuration page. See the table
"Switches 2, 3, and 4: Diagnostics". |
| 5 |
Start Job |
Up: The Sys/Start job on the hard disk does
not run. Down: The Sys/Start job runs if the
file exists on the disk. |
| 6 |
Set paper size |
Up: For metric-size media. Down:
For American-size media. |
| 7 |
Baud Rate |
Up: Fixed. Sets the serial communication parameters
to 1200 baud, software flagging, and ignore parity. Down:
Variable. Lets you change the serial communication parameters. The factory
setting is 9600 baud, software flagging, and ignore parity. For
information on how to change the serial port settings when Switch
7 is in the down position, refer to the Phaser 300X
Drivers and Utilities Printing Reference for details on the setdevparams
PostScript command. |
| 8 and 9 |
Color Correction |
See the table "Switches 8 and 9:
Color Correction Mode". |
