Botswana> change country
Phaser 300X


Setting up the printer
Note:The printer is shipped to you already loaded with ink. You do not need to add any ink when you first set up the printer.

Removing the shipping block

  1. Open the top cover.
  2. Hold down the button while you open the rear cover.
  3. Push the shipping block tab up and slide it, along with the printhead, past the post.
  4. Remove the shipping block, then close the covers.
Note:Save the shipping block to use again if you move the printer; the shipping block protects the head.

Caution:You must remove all packing material before turning the printer on, otherwise you will damage the printhead.

Loading paper

  1. Move the guides.
  2. Push down on the metal lift plate with your finger; then slide the paper under the tabs. When you use A-size (8.5 x 11 in.) or A4-size (210 x 297 mm) paper, place the long side of the paper under the tabs, making sure that the paper fits snugly against the inside front wall of the paper tray.
  3. Adjust the rear guide until it touches the rear of the paper.
    Note:The rear guide must fit snugly against the paper; otherwise the printed image might be clipped or rotated.
  4. Put the cover on the paper tray.
  5. Insert the paper tray into the printer. Tilt the paper tray up slightly as you insert it.
Note:To load transparencies, refer to "Making transparencies".

Installing the output tray

  1. Push the output tray into the lower slot until it clicks into place.
  2. Fit the rear tab into the slot inside the printer. The tabs on the sides of the tray fit into the slots on the sides of the printer.
If you need to remove the tray, press in on both sides of the tray next to the tabs while you pull out the tray.

Setting the media switch

Set Switch 6 for the paper size:
Support Home Page
Phaser 300X Support Page

Network Printers Support Home
Additional Information

Register your Printer
ASPs & TPMs
About Software Support
Color Connection
Printer Warranties
Material Safety Data Sheets
Supplies & Cartridge Recycling Program